• In foundation-curtain bundling.
• In the insulation of concrete surfaces which are in contact with water continuously.
• Roofs, verandas and balconies (with cover).
• Horizontally and vertically in building units where the insulation material should exhibit high crack bridging properties, cement-based substrates.
• Very humid indoor spaces.
• Bathrooms, under tiles.
• Asphalt, bitumen felts and so on.
• Waterproofing; in vertical and horizontal applications whether indoors or outdoors.
• In basements and underground parking lots.

• Rapid curing.
• It has excellent mechanical and chemical resistance properties and provides high tensile, tear and abrasion resistance.
• It adheres very strongly to different surfaces to form a highly elastic and durable film.
• It is effective in water vapor transmission.
• The film breathes and prevents moisture from accumulating in the substrate.
• It has the feature of bridging shrinkage cracks with its elastic structure.
• It is easily applied with roller or insulation pitch brush.
• No blowtorch is required during application.
• It forms a jointless, seamless, permanent, moisture and waterproof coating.
• Resistant to aging, water, various salt solutions and weak acids.
• Suitable for areas affected by frequent movement and vibrations.
• Resistant to plant roots.
• Excellent adhesion to almost any surface with or without lining.
• High thermal resistance.
• Resistant to freezing and thawing.

• The existing surface must be clean, dry, flat and free from dirt, dust, oil, wax, mold and effects that may deteriorate the performance of PROTECT-A PB 018 T.
• Any loose, dusty, cracked, crusted and pre-painted surfaces must be cleaned by abrasive blasting, sanding, wire brushing and / or machine assistance (pressurized water spray or sand blasting).
• Water pressure should be at least 1500 – 2000 psi.
• For metal roof surfaces, loose rust, tempering, surface adhesion or white rust on the metal surface should be removed from the surface using the above-mentioned methods.
• Damaged or weathered surfaces should be repaired.
• Surfaces contain paint and unevenness should be sanded.
• PROTECT-A PB 018 T should be mixed with a suitable mixer at 300 rpm for 2-3 minutes before application.
• The product is applied with spray or brush or roller in 2 coats with a total consumption of 1,5 – 2 kg / m2.
• Do not wait more than 24 hours between coats.
• If the application is to be carried out with spray, the material must be thinned with a suitable thinning agent (xylene).
• Equipment used during application should be cleaned immediately with a suitable solvent immediately after application.
• Depending on the surface condition, liquid membrane application should be started after priming with a suitable epoxy or polyurethane based primer. Surfaces to be applied must have at least the following standards:

Hardness: R28 = 15 mPa
Temperature: 5°C to 35°C
Relative Humidity: <85%