• Used for cutting off the pressure and leakage water coming from holes and deep cracks on foundations, basements, retaining walls, elevator shafts, pools, water tanks and concrete pipes.

For Interior and exteriors;

• Cement based substrates,
• Concrete,

Please consult us for all other application substrates.

• Suitable for use as powder or mortar.
• Very fast setting without shrinkage.
• Chloride-free structure.
• Very fast setting even under running water.

• The substrate should be clean, damp, smooth and sound.
• Dust, oil, paint and similar residues should be cleaned thoroughly using wire brush.
• The leaking hole should be drilled to a minimum of 3×3 cm to decrease water pressure.
• Make sure the depth-width ratio is 2/1.
• Plastic gloves must be worn before starting the application.
• Application as mortar: The mortar prepared with a little amount of water (0.25 liters of water for 1 kg powder) is mixed in a clean container to a dough consistency and kneaded quickly by hand.
• Protect 070 should be pressed in single move covering the entire hole as it starts setting by temperature increase and waited at least 30 seconds.
• The surface should be smoothed using trowel in the following minute.
• For large holes, first cover the surrounding area leaving a smaller hole in the middle, then repeat the application for the smaller hole.
• Application as powder: Make sure wearing gloves and take a handful powder, press the powder on the leakage area in a single move and wait at least 30 seconds.
• Keep pressing this way until Protect 070 completes setting and leakage stops.
• After Protect 070 hardens, level the substrate and switch to the next application.