PROTECT-A 060 U.V Ultra Elastic

PROTECT-A 060 U.V ULTRA ELASTIC

Bitumen emulsion based, one component, waterproofing product

Technical Specifications

Break extension	> % 900
Application temperature	+5˚C to +35˚C
Packaging	20 kg plastic bucket
Shelf life(25˚C 55%RH)	12 Months(Unopened)
Consumption(as a primer)	0.15 kg/m²
Consumption(2 – 3 layers)	2.0 – 3.0 kg/m
Drying time	1 -5 days
Complete drying time	24 hours
Viscosity	app. 8000 mPa.s
Density	1.2 kg/l
Solid matter ratio	>% 70
Plastic deformation	> % 60
µ value	app. 13000
Sd value (2mm for dry thickness)	app. 26 m

Description

PROTECT-A 060 U.V ULTRA ELASTIC is a highly elastic (%1000), single component, solvent free waterproofing material based on a unique combination of rubber and bitumen.

Area of Use

Foundations.
Seals joints of sealing membranes.
Underground garages and basements.
In the building industry and civil engineering.
Silos, silage containers, store-rooms and agricultural buildings, agriculture.
Terraces, balconies, flat roofs and planters.
Wet and damp rooms (under tiles).
Concrete, plaster, masonry, roofing felt, sealing membranes.
Protection of metal, wood, insulating material, porous concrete, synthetic materials, asbestos cement tiles, etc.

Product Features and Advantages

Creates dynamic crack-bridging.
Bonds to wet, dry, absorbent and non-absorbent surfaces.
Resistant to all dilute acids, alkalis, fumes and flue gasses commonly encountered in the industry.
Coatings are heat and cold resistant from -20°C to +200°C.
Supplied ready-to-use for cold application.
Single component, no mixing required.
Solvent free, can therefore be used without ventilation.
Can be used horizontal, vertical and overhead.
Can be used above and below ground.

Application Instructions

Make sure the intended application surface is solid and free from any frost, ponded water, oil, grease, paraffin, coatings, cement grout, any loose and weak particles or any other contaminants that could affect the process.
Surface should be prepared with appropriate mechanical preparation techniques (with the help of high-pressure washer and/or with the help of other abrasive equipment).
All dust, loose and materials that can easily crumble should be removed from the surface either with the help of a brush or by vacuuming.
Stir material thoroughly prior to application. Apply the Protect U.V. Ultra Elastic with roller, brush, squeegee, broom, trowel or suitable spraying device. Allow every coat to dry completely before applying the next one.
If it is necessary to prime the substrate, dilute Protect U.V. Ultra Elastic with water and apply it with a brush in one rich layer. Allow priming layer to cure thoroughly. Then apply the subsequent topcoats.
High humidity and/or low temperatures will prolong curing time.
Air and surface temperature for application must be +5°C to +30°C and must remain so for a minimum of 24 hours.
Do not apply on wet or frozen surfaces. Do not apply on dusting or weak surfaces. If in doubt, perform adhesion test.

[wpdm_package id=’2397′]

Leave us your info

Please fill in the form to request product samples or for your inquires and we will get back to you.